Netgear validating identity certificate Liveteenwebcam
cheere Hadn't read all solutions so I apologize if I'm repeating someone but all I did was go back to Belkin router setup utility, or (192.168.2.1) and clicked "wi fi protected setup".
Then, I selected disable at the "wi fi protected setup (wps)" option.
This seemed to work for me after I disconnected from my router and reconnected again.
However, you may have to go into "view wireless networks", and then choose "change order of preferred networks" in left corner of screen.
I have a laptop with a Dell D630 with Wi Fi power switch on the side.
Because I have a switch to disable the Wifi power, this seemed easier/safer, and it worked. thanks, Solution: remove whatever "preferred networks" are displayed in wireless netwok card's property page, n click ok. happens when u switch to a new router or use a new different SSID.
Then go to "authentification" tab and untick the box saying "Enable IEEE802.1x to the availiable network" and that should solve your problem Graham UKRight, Graham's solution worked for me.
In order to configure the connection back to Automatic, edit the eduroam profile, go to the Connection tab and check Connect when this network is in range: Figure 14: Setting Automatic connection  = If the Wireless Network Connection icon is not present, this may be due to the wireless network manager of your vendor's card taking over from Windows' built-in one (Wireless Zero Configuration).